37
Consumer Support
Installation Instructions
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
www.GEAppliances.com
Oven Light Replacement
CAUTION:
Before replacing your
oven light bulb, disconnect the electrical power
to the range at the main fuse or circuit breaker
panel. Be sure to let the light cover and bulb
cool completely.
The oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire. Remove the oven
door, if desired, to reach cover easily.
To remove:
Hold a hand under the cover so it
doesn’t fall when released. With
fingers of the same hand, firmly push
back the wire cover holder. Lift off
the cover.
Do not remove any screws to remove
the cover.
Do not touch hot bulb with a wet
cloth. Replace bulb with a 40-watt
household appliance bulb.
To replace cover:
Place it into the groove of the light
receptacle. Pull the wire forward to
the center of the cover until it snaps
into place. When in place, the wire
holds the cover firmly. Be certain the
wire is in the depression in the center
of the cover.
Connect electrical power to the range.
Oven Shelves
Clean the shelves with an abrasive cleanser.
The oven shelves may be cleaned in the
self-cleaning oven. However, the shelves
will darken in color, lose their luster and
become hard to slide if cleaned during
the self-cleaning cycle.
To make the shelves slide more easily, apply
a small amount of vegetable oil or cooking
oil to a paper towel and wipe the edges of
the oven shelves with the paper towel.
Wire cover holder.