GE JAS02M, Use And Care & Installation Manual

Anti-Tip Device Installation Instructions
for Device Kit No. WBO6XO1O3

I

● 

 RANGES CAN TIP

I

● 

 ● 

INSTALL ANTI-TIP

DEVICE PACKED WITH
RANGE

● 

SEE INSTRUCTIONS

Tools Needed

● 

Phillips head screwdriver

● 

 or adjustable wrench

● 

Flat blade screwdriver

Device attaches to floor or wall to
hold either right or left rear 
leveler. If 

 to floor, 

 sure

that screws do not penetrate
electrical wiring or plumbing. If
this cannot be determined, use

shorter screws that will not

penetrate through flooring.

Wall 

 range

Attachment 

to wall

Fig. 2

Wall plate

--

—

.

—

—

.-

1. Decide whether the device will

3. Determine whether you will

be installed on the right or left side

anchor the device to the floor or

of range location.

to the wall as shown in figure 2.

2. 

If the device side of the range

is adjacent to a cabinet, place the
device against back wall and
cabinet as shown in figure 1.

If there is no adjacent cabinet,
determine where the location of the

For greater stability fasten the
device to both the wall and the
floor if possible. Fasten the device
securely with the screws provided.
Screws are self-drilling in wood,
plywood, particle and chip board,
and most metal framing. If attaching

range side (painted outside panel)

to masonry you can 

 suitable 

-

will be. Place the device with its

screws and anchors at hardware

outside edge at this location and

stores. Use a masonry drill to drill

against back wall. See figure 1.

the required holes.

4. Using the wrench, back out the
four leg levelers at least two turns.
See your installation guide for
more leveling information before
positioning range.

5. Slide the range into place.

21