– 13 –
COOKTOP LIGHT REPLACEMENT
To Remove The Old Bulb:
1. Remove power to the unit.
2. Pull the range away from the wall.
3. Remove the two screws from the top edge
on the back of the range (A).
4. Pull up on the hand grips on the back of
the range (B) until the tabs at the bottom
of the cooktop light housing separate from
the back of the range.
5. Pull out the cooktop light housing as far as
possible - approx. 2 inches (C).
6. Remove the light bulb by unplugging it from
both sockets with one motion.
To Install The New Bulb:
1. Install the new light bulb by plugging it into
both sockets with one motion.
2. Using the hand grips on the cooktop light
housing (D), lift up and push the housing
back into the rear wall of the range. Then
lower the housing until the bottom tabs are
inserted back into the range.
3. Reinstall the two screws along the top edge
on the back of the range.
OVEN DOOR REMOVAL
The oven door is locked to the range cabinet
with hinge locks, located on top of both door
hinges.
To Remove The Oven Door:
1. Fully open the oven door.
2. Push the hinge locks down toward the door
frame, to the unlocked position.
3. Raise the door to the broil position.
4. Firmly grasp both sided of the door about
center ways down the door and lift upwards
to disengage the hinge arm from the hinge
slot. At the same time, pull the door to-
wards you while lifting it away from the
range.
To Reinstall Oven Door:
1. Firmly grasp both sides of the door and
insert the hinge arms into the door hinge
slots, while holding the door angle in the
broil position.
2. Lower the hinge arms downward, aligning
the hinge arm indentation to the lower por-
tion of the hinge slot.
3. Fully open the door.
4. Push the hinge locks up against the front
frame of the oven cavity, to the locked po-
sition.
SCREWS
A
2"
HAND
GRIPS
COOKTOP
LIGHT
HOUSING
B
LIGHT BULB
SOCKET
C
COOKTOP
LIGHT
HOUSING
HAND
GRIPS
D
HINGE LOCK
(UNLOCKED POSITION)
HINGE LOCK
(LOCKED POSITION)
SLOT
HINGE ARM
SEATED HINGE
ARM
LOWER HINGE ARM
INTO HINGE SLOT
