– 27 –
➍
ENERGIZE CONVECTION BAKE CIRCUIT - To
perform this test press CONVECTION BAKE then START
and listen for the convection bake relay to energize.
CAUTION: If you hold the start pad in, you are energizing
the convection element. As soon as you release the START
pad the relay will de-energize. If the relay does not
energize, check the following: Reconfirm that you have
entered the test mode correctly, check power and wiring
connections to the ERC, check for an open convection
element, and lastly suspect a faulty ERC.
➎
NUMERIC KEY PADS TEST - To perform proper
numeric key panel responses, press any numbered key pad
and hold it in for approximately 5 seconds; the number you
are pressing will show in the ERC display. If it does not,
reconfirm that you have entered the test mode correctly,
check wiring connections to the ERC and keypad ribbon.
➏
ENERGIZE OVEN LIGHT CIRCUIT - To perform this
test press OVEN LIGHT then START and listen for the oven
light relay to energize. Look through the front window of the
oven door to see the light come on. As soon as you release
the OVEN LIGHT pad the oven light relay will de-energize.
If the relay does not energize, check the following: reconfirm
that you have entered the test mode correctly, check power
and wiring connections to the ERC, check for an open light
bulb, and lastly, suspect a faulty ERC.
➐
ENERGIZE TOP PANEL LIGHT CIRCUIT - To perform
this test, press the TOP LIGHT key pad, and watch the top
fluorescent light energize. As soon as you release the TOP
LIGHT pad the fluorescent light will deenergize. If the light
does not energize, check the following: reconfirm that you
have entered the test mode correctly, check power and
wiring connections to the ERC, check for a defective bulb,
starter or ballast and lastly suspect a faulty ERC.
4
5
Conv. Bake
Circuit
Test
6
Oven Light
Circuit
Test
Numeric
Key pad
Test
EXAMPLE: Number 5 keypad pressed
7
Top Panel
Light Circuit
Test
