GE JBP56, Use And Care & Installation Manual

2. 

A. 

Connect length of copper building wire to

range terminal block.

B. 

Splice copper wires to aluminum wiring using

special connectors designed and 

 approved

for joining copper to aluminum, and follow the
connector manufacturer’s recommended
procedure closely.

 Wire used, location and enclosure of

splices, etc., must conform to good wiring

practice and local codes.

STEP 5
4-WIRE SYSTEM
SPECIAL GROUNDING INSTRUCTIONS

Frame grounded to neutral of appliance
through a link. If used in a MOBILE HOME or
if 

LOCAL CODES do not permit grounding

through the neutral:

1) disconnect the link from neutral,

2) use grounding terminal or lead to ground
unit in accordance with local codes, and
3) connect neutral terminal or lead to branch
circuit in usual manner.

(If the appliance is to be connected by

means of a cord set, use 4-conductor cord
for this

GROUND

4TH

LUG

STEP 6

ANTI-TIP BRACKET 

 bracket is supplied with instructions

for installation in a variety of locations. The
instructions include a template, a parts list and a
list of tools necessary to complete the installation.
Read the 

 INSTRUCTIONS

and the instructions that   your situation before
beginning installation.

WARNING

1. 

Range must be secured by ANTI-TIP bracket

supplied.
2. See instructions to instill (supplied with
bracket).
3. Unless properly installed, range could be

tipped by stepping or sitting on door. Injury

might result from spilled hot liquids or from
range 

Typical installation of Anti-Tip bracket

Attachment to Wall

Bracket

Screw Must Enter

Wood or 

Wall Plate

STEP 7
LEVELING THE RANGE

The 

range must be level. Leveling feet are located

at each corner of the base of the range. Remove
the storage drawer or kick panel (depending on

your model) and using channel locks, rotate the

leveling feet in and out as required to level the
range. (For instructions on how to remove and
replace the storage drawer or the kick panel, see
the Cleaning Under the Range section in Care
and Cleaning.) On some models, there are plastic
covers which may be removed for easy
adjustment 

 squeeze and pull).

One of the rear leveling feet will engage the

ANTI-TIP bracket (allow for some side to side

adjustment). 

 a minimum clearance of 

between the range and the leveling foot that is to
be installed into the 

 bracket.

Check the range for proper installation into the

ANTI-TIP bracket (after the range has been

properly installed) by grasping the edges of the
REAR burner holes and carefully attempting to
tilt the range forward.

STEP 
FINAL CHECK

Be sure all switches are in the “off” position
before leaving the range.

32