Featur
es of Y
our Oven Contr
ol
Oven Contr
ol, Clock and T
imer
OVEN CONTROL, CLOCK AND TIMER
Clock
To Set the Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
Baking or CLEAN cycle.
1. Press the CLOCK pad.
2. Press the + or – pad to set the
time of day.
3. Press the CLOCK pad to start.
–
+
CLOCK
Timer
To Set the Timer
The timer is a minute timer; it does
not control oven operations. The
maximum setting on the timer is
9 hours and 55 minutes.
1. Press the TIMER
ON/OFF pad.
2. Press the + or – pad to set the
amount of time on the timer.
The timer will start automatically
within a few seconds of releasing
the + or – pad.
The timer, as you are setting it,
will display hours and minutes.
“HR” will be in the display.
During the countdown, when the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.
TIMER
ON/OFF
To Reset the Timer
To Cancel the Timer
If both “SET” and “TIMER” are displayed, press the
+ or – pad until desired time is reached.
If only “TIMER” is displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
Press and hold the TIMER ON/OFF pad until the
word “TIMER” disappears from the display.
End of Cycle Tones
Power Outage
The end of cycle tone is a series of 3 beeps followed
by 1 beep every 6 seconds. If you would like to
remove the signal that beeps every 6 seconds, press
and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every 6 seconds, press
and hold the CLEAR/OFF pad for 10 seconds.
After a power outage, when power is restored, the
display will flash and time shown will no longer be
correct—for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
All other functions that were in operation when the
power went out will have to be programmed again.
Display Messages
Programmed information can be
displayed at any time by pressing
the pad of the operation you want
to see. For example, you can
display the current time of day
while the timer is counting down
by pressing the CLOCK pad. Press
the TIMER ON/OFF pad to return
to the timer display.
To check the start time for Delayed
Bake or Self-Clean, press and hold
the COOK TIME or AUTO SELF
CLEAN pad for 3 seconds. The
display will show the bake or clean
start time for as long as you press
the pad. When you release the pad,
the display will return to the time
of day.
If “door” appears in the display,
LOCK flashes, and the oven
control signals you set the self-
clean cycle and did not shut the
oven door.
(continued next page)
19
Summary of Contents for JBP95
Page 57: ...57 The Problem Solver NOTES...
Page 58: ...NOTES 58...
