Safety Instr
uctions
Operating Instr
uctions
Car
e and Cleaning
Tr
oubleshooting T
ips
Customer Ser
vice
Cleaning the glass cooktop.
(on some models)
Clean the glass surface with cleaning cream before you use the cooktop for the first time. Also, clean the glass
surface after each use. This helps protect the top and makes clean-up easier.
To clean the cooktop seal,
let a wet cloth rest on it for a few minutes, then wipe clean. Use a mild detergent if
needed.
Do not use a knife or any sharp object on the seal because it will cut or damage it.
Daily Cleaning
Use only a recommended cleaning cream,
such as Cerama Brite or the Cooktop
Cleaning Cream, on the glass cooktop.
To maintain and protect the surface of
your new glass cooktop follow these steps.
Before you use the cooktop for the first
time, clean it with cleaning cream.
This helps protect the top and makes
clean-up easier.
■
Clean the surface with the cleaning cream
after each use.
■
Rub a few drops (less is better) of the cleaning
cream onto soiled area using a damp paper
towel. Buff with a dry paper towel until all soil
and cream are removed.
For Heavy, Burned-On Soil…
Apply a few drops of the cleaning
cream to the (cool) soiled area.
Using a damp paper towel, rub the
cream into the burned-on area. As
with any burned-on spill, this may
require some effort.
Carefully scrape soil with razor
scraper. Hold scraper at a 30° angle
against the glass cooktop.
If any soil remains, repeat the steps
listed above. For additional
protection, after all soil has been
removed, polish the entire surface
with the cleaning cream.
Buff with a dry paper towel.
To order more cream and/or scrapers for
cleaning your glass cooktop, please call
our toll-free number:
National Parts Center . . . . . . . . . 800-626-2002
Cleaner
. . . . . . . . . . . . . . . . . . . . . # WX10X300
Scraper
. . . . . . . . . . . . . . . . . . . . . # WX5X1614
Cream & scraper kit
. . . . . . . . . # WB64X5027
Special Care
Be sure to use a new sharp razor scraper. Do not
use a dull or nicked blade.
Sugary spillovers (such as jellies, fudge,
candy syrups) or melted plastics can
cause pitting of the surface of your
cooktop (not covered by the warranty)
unless the spill is removed while still hot.
Special care should be taken when
removing hot substances.
Turn off all surface units affected by
the spillover. Remove hot pans.
Wearing an oven mitt, hold the razor
scraper at a 30° angle to the cooktop.
Scrape the hot spill to a cool area
outside the surface unit.
With the spill in a cool area, use a dry
paper towel to remove any excess.
Any spillover remaining should be
left until the surface of the cooktop
has cooled. Do not continue to use
the soiled surface unit until all of the
spillover has been removed. Follow
the steps under
Heavy Burned-On Soil
to continue the cleaning process.
NOTE:
If pots with a thin overlay of aluminum,
copper or enamel are allowed to boil dry, the
overlay may bond with the glass cooktop and
leave a black discoloration. This should be
removed immediately before heating again or the
discoloration may be permanent.
Using a razor scraper will not
damage the surface if the 30° angle
is maintained.
17
