9
Note:
Flat-bottomed canners are
required for glass cooktops.
Pots that extend beyond 2.5 cm
of the surface unit’s circle are not
recommended for most surface
cooking. However, when canning
with water-bath or pressure canner,
larger-diameter pots may be used.
This is because boiling water
temperatures (even under pressure)
are not harmful to the cooktop
surfaces surrounding the surface units.
HOWEVER, DO NOT USE LARGE-
DIAMETER CANNERS OR OTHER
LARGE-DIAMETER POTS FOR
FRYING OR BOILING FOODS
OTHER THAN WATER. Most syrup
or sauce mixtures—and all types of
frying—cook at temperatures much
higher than boiling water. Such
temperatures could eventually harm
the glass cooktop surfaces.
Be sure the canner fits over the
center of the surface unit. If your
cooktop or its location does not
allow the canner to be centered
on the surface unit, use smaller-
diameter pots for good canning
results.
Flat-bottomed canners must be
used. Do not use canners with
flanged or rippled bottoms (often
found in enamelware) because
they don’t make enough contact
with the surface units and take
a long time to boil water.
When canning, use recipes and
procedures from reputable
sources. Reliable recipes and
procedures are available from the
manufacturer of your canner;
manufacturers of glass jars for
canning, such as Ball
®
and Kerr
®
brand; and the United States
Department of Agriculture
Extension Service.
Remember that canning is a
process that generates large
amounts of steam. To avoid burns
from steam or heat, be careful
when canning.
NOTE:
If your house has low voltage,
canning may take longer than expected,
even though directions have been
carefully followed. The process time will
be shortened by:
(1) using a pressure canner, and
( 2) starting with HOT tap water for fastest
heating of large quantities of water.
CAUTION:
■
Safe canning requires that harmful
microorganisms are destroyed and
that the jars are sealed completely.
When canning foods in a water-bath
canner, a gentle but steady boil must be
maintained for the required time. When
canning foods in a pressure canner, the
pressure must be maintained for the
required time.
■
After you have adjusted the controls,
it is very important to make sure the
prescribed boil or pressure levels are
maintained for the required time.
■
Since you must make sure to process
the canning jars for the prescribed
time, with no interruption in processing
time, do not can on any cooktop
surface unit if your canner is not flat.
Observe the Following Points in Canning
Wrong!
Right!
www.GEAppliances.ca
S
a
fe
ty
In
st
ru
c
tio
n
s
O
p
e
ra
tin
g
In
st
ru
c
tio
n
s
C
a
re
a
n
d
C
le
a
n
in
g
Tr
o
u
b
le
sh
o
o
tin
g
T
ip
s
C
o
n
su
m
e
r S
u
p
p
o
rt
Summary of Contents for JCD968
Page 46: ...46...
