CONVERTING SURFACE BURNERS
MODELS EQUIPPED
SEALED BURNERS
(See
Step 4 if range is equipped with standard
twin burners.)
1. Remove grates, burner caps and burner heads.
2. Using a
remove the burner bases
by unscrewing the 3 small screws in each base.
the burner straight out.
DO NOT disconnect the wires from the burner
bases unless the
needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing spud from fitting with
a 7 mm or a small adjustable wrench (depending
on the size of your spuds). Apply a 3/4” wrench
to the hex on
gas inlet tube as a back-up
when removing spud to prevent the
aluminum from
4. Install
spuds according to one of the
following diagrams
❑
or
for
gas
or natural gas, depending on which you are
converting to.
❑
orifice
Spuds
spuds are in a small plastic bag packed
with this Use and Care Guide.
spuds
have a 2-digit number and the letter “L” on one
side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on the
range where it is to be installed as shown below.
❑
Natural gas orifice spuds have a 3-digit number
on one side. Each
spud will also have 1, 2
or 3 grooves on one side, with the letter “N”
underneath denoting the location on the range
where it is to be installed as shown below.
(continued next page)
45
Summary of Contents for JG5P34
Page 52: ...NOTES 52 ...
Page 53: ...NOTES 53 ...