Your new cooktop has gas burners. If you are used
The best types of cookware to use, plus heat-up and
to cooking with induction or other electric surface
cool-down times, depend upon the type of burner or
units, you will notice some differences when you use
surface unit you have.
gas burners.
The following chart will help you to understand the
differences between gas burner
and any
other type of cooktop you may have used in the past.
of Cooktop
Gas Burners
—
Radiant
(Glass Ceramic)
Cooktop
o
Induction
“//,,,,,,,\\\
Electric Coil
o
Solid Disk
Description
Regular or sealed
gas burners use
either
gas
or natural gas.
Electric coils
under a
ceramic cooktop.
High frequency
induction coils
under a glass
surface.
Flattened metal
tubing containing
electric resistance
wire suspended
over a drip pan.
Solid cast iron
disk sealed to the
cooktop surface.
How it Works
Flames heat the pans directly. Pan flatness is not critical to cooking results, but
pans should be well balanced. Gas burners heat the pan right away and change
heat settings right away. When you turn the control off, cooking stops right away.
Heat travels to the glass surface and then to the cookware, so pans must be flat on
the bottom for good cooking results. The glass cooktop stays hot enough to
continue cooking after it is turned off. Remove the pan from the surface unit if
you want cooking to stop.
Pans must be made of ferrous metals (metal that attracts a magnet). Heat is
produced by a magnetic circuit between the coil and the pan. Heats up right away
and changes heat settings right away,
a gas cooktop. After turning the control
off, the glass cooktop is hot from the heat of the pan, but cooking stops right away.
Heats by direct contact with the pan and by heating the air under the pan. For best
cooking results, use good quality pans. Electric coils are more forgiving of
warped pans than radiant or solid disks. Heats up quickly but does not change
heat settings as quickly as gas or induction. Electric coils stay hot enough to
continue
for a short time after they are turned off.
Heats by direct contact with the pan, so pans must be flat on the bottom for good
cooking results. Heats up and cools down more slowly than electric coils. The
disk stays hot enough to continue cooking after it is turned off. Remove the pan
from the solid disk if you want the cooking to stop.
Lighting Instructions for Electric Ignition Models
Your surface burners are lighted by electric ignition,
Surface burners in use when an electrical power
eliminating the need for standing pilot lights with
failure occurs will continue to operate normally.
constantly-burning flames.
In case of a power failure, you can
the surface
burners on your range with a match. Hold a lighted
match to the burner, then turn the knob to the
position. Use
extreme caution when lighting
burners this way.
The electrode of the spark igniter is exposed.
When one burner is turned to
all the burners
spark. Do not attempt to disassemble or clean
around any burner while another burner is on.
An electric shock may result, which could cause
you to knock over hot cookware.
(continued next page)
9
