33
ge.com
Wire cover holder.
Oven Shelves
Clean the shelves with an abrasive cleanser
or scouring pad. After cleaning, rinse the
shelves with clean water and dry with a
clean cloth.
If the shelves ever become hard to slide, wipe
the shelf edges or oven shelf supports with
vegetable oil.
NOTE:
Take the shelves out of the oven before
you begin the self-clean cycle or they may
discolor.
Oven Light Replacement
CAUTION:
Before replacing your
oven light bulb, disconnect the electrical power
to the range at the main fuse or circuit breaker
panel. Be sure to let the light cover and bulb
cool completely.
The oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire. Remove the oven
door, if desired, to reach cover easily.
To remove:
Hold a hand under the cover so it
doesn’t fall when released. With fingers
of the same hand, firmly push back the
wire cover holder. Lift off the cover.
Do not remove any screws to remove
the cover.
Do not touch hot bulb with a wet cloth.
Replace bulb with a 40-watt household
appliance bulb.
To replace cover:
Place it into the groove of the light
receptacle. Pull the wire forward to the
center of the cover until it snaps into
place. When in place, the wire holds the
cover firmly. Be certain the wire is in the
depression in the center of the cover.
Connect electrical power to the range.
Consumer
Ser
vice
Operating
Instructions
Safety
Instructions
Installation
Instructions
Tr
oubleshooting
Tips