27
If you have questions, call 800.GE.CARES or visit our Website at: ge.com
Installation
Range
Instructions
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
Installation of this range must conform with
local codes, or in the absence of local codes,
with the National Fuel Gas Code, ANSI
Z223.1/NFPA.54, latest edition. In Canada,
installation must conform with the current
Natural Gas Installation Code, CAN/CGA-B149.1
or the current Propane Installation Code,
CAN/CGA-B149.2, and with local codes where
applicable. This range has been design-certified
by CSA International according to ANSI Z21.1,
latest edition and Canadian Gas Association
according to CAN/CGA-1.1 latest edition.
As with any appliance using gas and generating
heat, there are certain safety precautions you
should follow. You will find these precautions in the
Important Safety Information
section in the front
of this manual. Read them carefully.
•
IMPORTANT
—
Save these instructions
for local inspector’s use.
•
IMPORTANT
—
Observe all governing
codes and ordinances.
• Note to Installer –
Be sure to leave these
instructions with the Consumer.
• Note to Consumer –
Keep these instructions for
future reference.
• Note –
This appliance must be properly
grounded.
• Servicer –
The electrical diagram is in an
envelope attached to the back of the range.
• Skill Level –
Installation of this appliance
requires basic mechanical skills.
•
Proper installation is the responsibility of the
installer.
•
Product failure due to improper installation is not
covered under the Warranty.
IN THE COMMONWEALTH OF
MASSACHUSETTS
•
This product must be installed by a licensed
plumber or gas fitter.
•
When using ball-type gas shut-off valves, they
shall be the T-handle type.
•
A flexible gas connector, when used, must not
exceed 3 feet.