41
LEVEL THE RANGE
Install the oven shelves in the oven and
position the range where it will be installed.
Check for levelness by placing a spirit level
or a cup, partially filled with water, on one of
the oven shelves. If using a spirit level, take
two readings—with the level placed diagonally
first in one direction and then the other.
Remove the broiler drawer or kick panel.
See the
Care and cleaning of the range
section.
The front leveling legs can be adjusted from
the bottom and the rear legs can be adjusted
from the top or the bottom.
Use an open-end or adjustable wrench to
adjust the leveling legs until the range is level.
After the range is level, slide the range away
from the wall so that the Anti-Tip device can
be installed.
E
D
C
B
A
6
Leg
leveler
Lower
range
Raise
range
(on some models)
Raise
range
Lower
range
(on some models)
Installation Instructions
INSTALL THE ANTI-TIP DEVICE
Mark the wall where the
RIGHT EDGE
of the range is to be located. Be sure
to allow for the countertop overhang
if you intend to install the range next
to cabinets.
Locate the outside edge of the device 2
1
⁄
8
″
toward the center of the range from the
marked edge of the range.
Using the device as a template, mark the
position of the hole for the screw.
C
B
A
7
WARNING
—
•
If the Anti-Tip Device supplied with the range
does not fit this application, use the Anti-Tip
Device WB02k10020.
•
Range must be secured with an approved
Anti-Tip device.
•
Unless properly installed, the range could be
tipped by you or a child standing, sitting or
leaning on an open door.
•
After installing the Anti-Tip device, verify that
it is in place by carefully attempting to tilt the
range forward.
•
This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
•
The use of this device does not preclude
tipping of the range when not properly
installed.
Anti-Tip
device
Slotted head
screw
Approx.
20°
2
1
⁄
8
″
Wallplate
Marked edge
of range
