OVEN CONTROL, CLOCK AND TIMER
Clock
To Set the Clock
The clock must be set to the correct time of day for
the automatic oven timing functions to work properly.
The time of day cannot be changed during a Timed
Baking or Self-Cleaning cycle.
c1
1.
Press the CLOCK pad.
CLOCK
‘n
2. Press the INCREASE or DECREASE
day.
Timer
To Set the Timer
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 55
c1
1. Press the TIMER
TIMER
ON/OFF pad.
ON/OFF
minutes.
2. Press the INCREASE or
DECREASE pad to set the
amount of time on the timer.
The timer will start automatically
within a few seconds of
the pad. The timer, as you are
setting it, will display seconds until
1 minute is reached. Then it will
display minutes and seconds until
60 minutes is reached.
After 60 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
—
To Reset the Timer
To Cancel the Timer
If “TIMER” is displayed, press the INCREASE or
Press and hold the TIMER ON/OFF pad until the
DECREASE pad
the desired time is reached.
word “TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tones
The end of cycle tone is 3 short beeps followed by
To return the end of cycle tone to the repeating beeps,
1 beep that repeats every 6 seconds until you press
press and hold the CLEAR/OFF pad for 10 seconds.
any operation. If you would like to eliminate the
repeating beeps, press and hold the
pad
for 10 seconds.
Power Outage
Display Messages
After a power outage, when power is restored the
If “door” appears in the display, the oven door is
display will flash and time shown will no longer
opened and needs to be closed. If “LOCK” appears
be correct-for example, after a 5-minute power
in the display, the oven door is in the locked position.
interruption the clock will be 5 minutes slow. The
BAKE, BROIL and COOK TIME cannot be set if the
—
display flashes until the clock is reset.
other
door is in the locked position.
functions that were in operation when the power
went out will have to be programmed again.
12
