TOOLS YOU WILL NEED
MATERIALS YOU MAY NEED
1
229C
4053P535
31-10552
03-03 JR
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com
Installation
Gas Slide-In Range
Instructions
JGSP48, JGS968
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
•
IMPORTANT
—
Save these
instructions for local inspector’s use.
•
IMPORTANT
—
Observe all
governing codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these
instructions for future reference.
•
Product failure due to improper installation
is not covered under the Warranty.
WARNING
—
This appliance must
be properly grounded.
•
IMPORTANT
—
Leak testing of the
appliance shall be conducted according to
the manufacturer’s instructions.
•
Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
IN THE COMMONWEALTH OF
MASSACHUSETTS:
•
This product must be installed by a
licensed plumber or gas fitter.
•
When using ball-type gas shut-off valves,
they shall be the T-handle type.
•
A flexible gas connector, when used, must
not exceed 3 feet.
PARTS INCLUDED
Anti-Tip Bracket
Shut Off Valve
Pipe Fittings
CSA-Approved Flexible Gas Line
3/8
″
Min. ID, 1/2
″
NPT Connection,
3-foot Maximum Length (Massachusetts Only)
Joint Sealant
Wrench or Pliers
(for 1-7/16” Nut)
Level
1/4” Nut Driver
Safety Glasses
Drill
Tape Measure
Screws
Rear Filler
2 Screws
Phillips Head
Screwdriver
Pipe Wrench
