To Set the Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
Bake or CLEAN cycle.
❑
1. Press the
CLOCK pad.
CLOCK
2. Press the
A
INCREASE or
DECREASE pad
to set the time
of day.
3. Press the CLOCK pad to start.
Timer
To Set the Timer
The timer is a minute timer; it does
not control oven operations. The
maximum setting on the timer is
9 hours and 55 minutes.
1. Press the TIMER
TIMER
ON/OFF pad.
2. Press the INCREASE or
DECREASE pad to set the
amount of time on timer.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE pad.
The timer, as you are setting it,
will display hours and minutes;
“HR” will be in the display.
During the countdown, when the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.
To Cancel the Timer
is displayed, press the INCREASE or
Press and hold the TIMER ON/OFF pad
DECREASE pad until the desired time is reached.
word “TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
the
End of Cycle Tone
The end of cycle tone is a series of 3 beeps followed by 1 beep every
6 seconds. If you would like to remove the signal that beeps every 6
seconds, press and hold the
pad for 10 seconds.
To return the signal that beeps every 6 seconds, press and hold the
pad for 10 seconds.
Power Outage
After a power outage, when power is restored, the display will flash and
time shown will no longer be correct—for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
All other functions that were in operation when the power went out will
have to be programmed again.
7
●
