8
Find the studs, using one of the following methods:
A.
Stud finder – a magnetic device which locates nails.
OR
B.
Use a hammer to tap lightly across the mounting
surface to find a solid sound. This will indicate
a stud location.
After locating the stud(s), find the center by probing
the wall with a small nail to find the edges of the stud.
Then place a mark halfway between the edges.
The center of any adjacent studs should be 16
s
or 24
s
from this mark.
Draw a line down the center of the studs.
IMPORTANT:
The microwave must be connected to at
least one wall stud.
1
Remove the box containing the installation
instructions, filters, exhaust adaptor, damper
and the small hardware bag. Do not remove
the foam packing protecting the front of the oven.
Fold back all 4 carton flaps fully against carton sides.
Then carefully roll the oven and carton over onto
the top side. The oven should be resting in the foam
packing.
REMOVING THE OVEN FROM
7+(&$57215(029,1*
THE MOUNTING PLATE
),1',1*7+(:$//678'6
B
A
2
PLACEMENT OF THE MOUNTING PLATE
1
Wall
Studs
Center
3
Carton
Pull the carton up and off the oven.
Open the oven door and remove the foam pack
from inside the oven. Remove the tape covering the
turntable hub.
Foam
packing
Installation Instructions
2
3
6
Set the oven upright. Remove and properly discard
plastic bags and foam packing.
1
The mounting plate is attached to the back of the
oven. Remove the two screws holding it to the oven.
The plate will be used as the rear wall template and
for mounting the oven to the wall.
4
5
Summary of Contents for JNM7196SFSS
Page 24: ...24 Printed in Korea...
