7
Installation Instructions
7
POWER CORD AND STRAIN
RELIEF INSTALLATION
•
For power cord installations only
(see the
next step if using conduit), assemble the
strain relief in the hole. Insert the power
cord through the strain relief and tighten.
Allow enough slack to easily attach the cord
terminals to the terminal block. If tabs are
present at the end of the winged strain
relief, they can be removed for better fit.
NOTE: Do not install the power cord
without a strain relief. The strain relief
bracket should be installed before
reinstalling the rear range wiring cover.
Skip to applicable power cord installation.
1
Power cord
Strain relief
Terminal
block
Bracket
CONDUIT AND SQUEEZE
CONNECTOR INSTALLATION
•
For conduit installations only,
purchase a
squeeze connector matching the diameter
of your conduit and assemble it in the hole.
Insert the conduit through the squeeze
connector and tighten. Allow enough slack
to easily attach the wires to the terminal
block.
NOTE:
Do not install the conduit without a
squeeze connector. The squeeze connector
should be installed before reinstalling the
rear range wiring cover.
Skip to applicable conduit installation.
2
Squeeze
connector
Terminal
block
Conduit
Bracket
Fig. 13
Fig. 14
