background image

Use and Care & Installation Guide

Convertible Range Hood

Models: JV356 30

JV656 36

Write Down the Model and Serial Numbers.

The Model and Serial Numbers are on a label on the
back wall of the hood and on the Consumer Product
Ownership Registration Card that came with your hood.
Before sending in this card, please write these numbers here:

Model Number

Serial Number

IMPORTANT SAFETY INSTRUCTIONS

Read and save these instructions.

WARNING—TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the

manufacturer. If you have questions, contact the
manufacturer at the address or telephone number
listed in the warranty.

B. Before servicing or cleaning unit, switch power 

off at service panel and lock service to prevent 
power from being switched on accidentally. When 
the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such 
as a tag, to the service panel.

C. Installation work and electrical wiring must be done by

qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.

D. Sufficient air is needed for proper combustion and

exhausting of gases through the flue (chimney) of fuel-
burning equipment to prevent backdrafting. Follow the
heating equipment manufacturer’s guidelines and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code authorities.

E. When cutting or drilling into wall or ceiling, do not

damage electrical wiring and other hidden utilities.

F. Ducted fans must always be vented to the outdoors.
G. To reduce the risk of fire, use only metal ductwork.
H. This unit must be grounded.
WARNING—TO REDUCE THE RISK OF A
RANGE TOP GREASE FIRE:
A. 
Keep fan, filters and grease-laden surfaces clean.
B. Always turn hood ON when cooking at high heat.
C. Don’t leave range unattended when cooking.
D. Use high settings on range only when necessary. 

Heat oil slowly on low to medium setting.

E. Always use cookware and utensils appropriate for the

type and amount of food being prepared.

• When flaming foods under the hood, turn the fan on.
WARNING—TO REDUCE THE RISK OF INJURY
TO PERSONS IN THE EVENT OF A RANGE TOP
GREASE FIRE, OBSERVE THE FOLLOWING:
A. 
SMOTHER FLAMES with a close-fitting lid, cookie

sheet, or metal tray, then turn off the burner. BE
CAREFUL TO PREVENT BURNS. If the flames do
not go out immediately, EVACUATE AND CALL
THE FIRE DEPARTMENT.

B. NEVER PICK UP A FLAMING PAN—You may be

burned.

C. DO NOT USE WATER, including wet dishcloths or

towels—a violent steam explosion will result.

D. Use an extinguisher ONLY if:

1. You know you have a Class ABC extinguisher, 

and you already know how to operate it.

2. The fire is small and contained in the area where 

it started.

3. The fire department is being called.
4. You can fight the fire with your back to an exit.

*Based on “Kitchen Firesafety Tips” published by NFPA.
CAUTION—For general ventilating use only. Do not use
to exhaust hazardous or explosive materials and vapors.

If You Need Service…

• Do not attempt to repair or replace any part of your

hood unless it is specifically recommended in this
guide. All other servicing should be referred to a
qualified technician.

SAVE THESE INSTRUCTIONS

GE Appliances

164D2966P165-2

Summary of Contents for JV356 30

Page 1: ...into wall or ceiling do not damage electrical wiring and other hidden utilities F Ducted fans must always be vented to the outdoors G To reduce the risk of fire use only metal ductwork H This unit must be grounded WARNING TO REDUCE THE RISK OFA RANGE TOP GREASE FIRE A Keep fan filters and grease laden surfaces clean B Always turn hood ON when cooking at high heat C Don t leave range unattended whe...

Page 2: ... Remove the blower motor by removing the packing screw and the clip on the retainer bar Discard the clip and screw Unplug the motor from the junction box Snap the blower retainer bar toward the rear of the hood to release the blower Remove the blower 3 Remove the junction box cover Remove the selected wiring knockout and duct knockout from the top or rear of the hood Use a flat blade screwdriver t...

Page 3: ...l screws 8 x 1 4 Check the damper for free operation Open the damper blade to approximately 80 degrees Position the blower for vertical discharge The air flow arrow on the blower should point up towards the vent opening When the blower is in position snap the blower retainer bar toward the front into the indent Reattach the plug into the junction box Blower discharge Air flow arrow This surface to...

Page 4: ...o use the product Read your Use and Care material If you then have any questions about operating the product please contact your dealer or our Customer Relations office at the address below or call toll free GE Answer Center 800 626 2000 consumer information service Improper installation If you have an installation problem contact your dealer or installer You are responsible for providing adequate...

Reviews: