Installation Instructions
Place the trim frame over the microwave oven with the
curved edge at the top.
Press the trim frame into the opening until all sides snap
into place.
Open the microwave oven door. Secure the trim frame
using four flat-head screws (two on the inside top and two
on the inside bottom).
A
B
C
Your trim kit is now fully installed. Replace the turntable
and turntable support that were removed from the inside
of the microwave oven.
Keep these installation instructions and extra screws for
future reference and need. Do not place them in the
microwave oven.
Replace house fuse or close circuit breaker.
A
B
❒
REPLACE ANY LOOSE ITEMS
10
MFL38268401
49-40552
07-07 JR
Printed in China
C
❒
INSTALL THE TRIM FRAME
9
Check the leveling by placing a
level at the front and sides of the
microwave. It may be necessary to
add wood shims under the bottom
duct to level the microwave
front-to-back or side-to-side.
❒
CHECK LEVELING
6
Flat-Head
Screws
Flat-Head Screws
❒
INSTALL THE TOP BRACKET
7
Ensure that
Top Bracket
is Level
Align Center
Lines on
Cabinet and
Top Bracket
Mark Screw
Hole Locations
(also on left
side of bracket)
Place the top bracket flange on top of the upper duct with
the opening of the top bracket lined up with the opening
on the upper duct.
Align the center line marking on the top bracket with the
center line drawn on the top front face of the cabinet at the
center of the cutout.
Ensure the top bracket is level and mark screw hole
locations on the cabinet face.
Drill pilot holes through the side holes in the top bracket.
Secure the top bracket to the cabinet using four round-head
screws (see illustration in step 8).
A
B
C
D
❒
INSTALL THE BOTTOM BRACKET
AND SECURE THE TOP BRACKET
8
Round-Head
Screws
Cutout
Opening
Positioning
Flange
Drill pilot holes through the three holes on the front flange
of the bottom duct assembly.
Hold the bottom bracket against the front flange of the
bottom duct assembly, lining up the three holes in the
bottom bracket with the three holes in the bottom duct.
Screw in three round-head screws. Drill pilot holes through
the four holes in the tabs on the sides of the bottom bracket.
Screw in four round-head screws.
A
B
