21
Charging the Battery
If it is necessary to charge the battery, proceed as follows:
1. Set control board system switch to
OFF
.
2. Remove 15 Amp fuse from control panel.
3. Disconnect negative battery cable from negative
battery terminal (indicated by
NEGATIVE
,
NEG
, or (
-
)).
4. Charge battery with battery charger at 2 Amps until
battery holds 12 Volts.
NOTE
: DO NOT exceed 13.7 volts when charging.
5. Connect negative battery cable to negative battery
terminal (indicated by
NEGATIVE
,
NEG
, or (
-
)).
6. Ensure hardware on both positive and negative
battery terminals is secure.
7. Reinstall 15 Amp fuse in control panel.
8. Set generator’s system switch to
AUTO
.
9. Reset exercise timer. See
Setting Exercise Timer
.
NOTICE
Failure to disconnect negative battery cable will result in
equipment failure.
DO NOT attempt to jump start the generator.
•
Damage to equipment resulting from failure to follow this
•
instruction will void engine and generator warranty.
WARNING
Storage batteries give off explosive hydrogen gas
during recharging.
Slightest spark will ignite hydrogen and
cause explosion.
Battery electrolyte fluid contains acid and is
extremely caustic.
Contact with battery contents will cause severe chemical burns.
A battery presents a risk of electrical shock and high short
circuit current.
DO NOT dispose of battery in a fire. Recycle battery.
•
DO NOT allow any open flame, spark, heat, or lit cigarette during
•
and for several minutes after charging a battery.
DO NOT open or mutilate the battery.
•
Wear protective goggles, rubber apron, rubber boots and
•
rubber gloves.
Remove watches, rings, or other metal objects.
•
Use tools having insulated handles.
•
CAUTION
With the system switch set to
AUTO
, the engine may
crank and start at any time without warning.
To prevent possible injury that may be caused by such sudden
•
starts, always set the system switch to
OFF
if performing
maintenance on the system.
Remove the 15 Amp fuse before working on or around the
•
generator or transfer switch.
Cleaning the Generator
1. Set control board system switch to
OFF
.
2. Remove 15 Amp fuse from control panel.
3. Clean generator as desired.
• Use a damp cloth to wipe exterior surfaces clean.
• Use a soft, bristle brush to loosen caked on dirt, etc.
• Use a vacuum cleaner to pick up loose dirt and debris.
• Use low pressure air (not to exceed 25 psi) to blow
away dirt. Inspect cooling air slots and openings on
the generator. These openings must be kept clean
and unobstructed.
4. Reinstall 15 Amp fuse in control panel.
5. Set generator’s system switch to
AUTO
.
6. Reset exercise timer. See
Setting Exercise Timer
.
NOTICE
: Improper treatment of generator can damage it and
shorten its life.
DO NOT expose generator to excessive moisture, dust, dirt, or
•
corrosive vapors.
DO NOT insert any objects through cooling slots.
•
Not
for
Reproduction
