GE
PROPRIETARY TO GE
D
IRECTION
5308917-100, R
EVISION
8
LOGIQ P3 S
ERVICE
M
ANUAL
Chapter 8 Replacement Procedures
8-31
8-3-2
Keyboard Knob Set (FRU P/N: 5315502 - P3, 5443870 - P3 BT) & Encoder set
(FRU P/N: 5262796 - P3, 5455710 - P3BT)
This is a description on how to remove and replace the Keyboard knob set Assembly.
8-3-2-1
Tools
•
Common Torx screwdrivers
NOTE:
B Mode Gain Knob Encoder is not a FRU.
8-3-2-2
Needed Manpower
•
1 person, 15 minutes
8-3-2-3
Preparations
•
Shutdown the system and switch off the main Circuit Breaker at the bottom rear side of the system.
8-3-2-4
Removal procedure
1) Pull the knobs out with hands by slightly pushing it up from the bottom edge.Refer
Figure 8-33 Keyboard knob set
8-3-2-5
Mounting procedure
1.) Install the new parts in the reverse order of removal.
8-3-2-6
Functional Checkout Procedure
Functional Test
Debrief Script
Do Visual Inspection and ensure
no scratches observed and
fitment is done properly
Service Manual Direction 5308917-100, Section 8-3-3. Equipment passes all required
tests and is ready for use.
Encoder knob
Depth Knob
TGC Knob