GE HealthCare CONFIDENTIAL
Direction
5936427
, Rev. 1
LOGIQ Totus
Basic Service Manual
4 - 10
Section 4-2 - General Procedures
4-2-4
Power shut down
When you switch OFF the LOGIQ Totus, the Ultrasound system performs an automatic shutdown
sequence.
1.) Press once on the
ON/OFF
button on the operator panel to display the
SYSTEM - EXIT
menu.
2.) Select
Shutdown
to shutdown the system..
4-2-5
Complete power down
1.) Press once on the
ON
/
OFF
button on the operator panel to display the
SYSTEM - EXIT
menu
2.) Select
Shutdown
to do a complete power down of the LOGIQ Totus.
The back end will first turn off the LOGIQ Totus activity and print the message “Please wait -
Shutdown in progress” in the display on the operator panel.
Next, it starts to shut down. The time to turn down the LOGIQ Totus, including the back end, may
vary from 10 seconds up to approximately 1 minute.
The last thing that shuts down, is the light on the operator panel, indicating that you can continue
with the next step.
3.) Switch off the Mains Power Circuit Breaker, located on the rear of the LOGIQ Totus. This will cut
power distribution within the LOGIQ Totus.
Table 4-3 SYSTEM - EXIT Menu
Corresponding Graphic
The
SYSTEM - EXIT
menu, used when switching OFF the LOGIQ Totus, gives you these
choices:
Logoff
:
Use this button to log off the current user.
The Ultrasound system remains ON and ready for a new user to log on.
If the
Logoff
button is dimmed, it indicates that no user is logged on to the LOGIQ Totus at the
moment.
Shutdown
:
Use this button to shut down the Ultrasound system. The entire system will shut down. It is
recommended to perform a full shutdown at least once a week.
If the
Shutdown
button is dimmed, press the ON/OFF button or
Alt+F10
to shut down the
LOGIQ Totus.
Cancel
:
Use this button to exit from the
SYSTEM - EXIT
menu and return to the previous operation.
Exit
(Only available when logged in as GE HealthCare Service with an SSA key):
Select this button when you want to exit to the Windows desktop.
NOTICE
Risk of losing data. Be sure to wait with the next step until the LOGIQ Totus has finished its shut-down.
Failing to do so may destroy data on the hard disk drive, making the LOGIQ Totus fail later.
Summary of Contents for LOGIQ Totus
