Troubleshooting
3.
Perform the
50mm/s Speed Test
.
a.
Select
50mm/s Speed Test
.
The writer prints the 50 mm/s speed test report.
b.
When one page of the report has printed, press
Stop
.
The following window opens.
c.
Examine the printed report.
Use the following criteria to determine if the writer passed or failed the
50mm/s speed test.
• If one cycle of the square wave spans 50 mm on paper, measured from
corner to corner of the wave, with an allowable tolerance of 1.0 mm,
the test passes.
• If this criteria is not met, the test fails.
d.
If the test passed, press
F4
(
Yes
).
If the test failed, press
F5
(
No
).
4.
Repeat the previous step for the other speed tests. The pass-fail criteria for each
of the remaining tests are as follows:
•
25mm/s Speed Test
If one cycle of the square wave spans 25 mm on paper, measured from
corner to corner of the wave, with an allowable tolerance of 0.5 mm (2%),
the test passes.
If this criteria is not met, the test fails.
•
12.5mm/s Speed Test
Measure five or more cycles and divide your measurement by the number
of cycles measured.
40
MAC™ 1600
2028451-183E
Summary of Contents for MAC 1600
