Maintenance
Replacing Queue Mark Sensor
The queue mark sensor performs the paper queuing function if you are using the
thermal paper with queue marks. Use the following procedure to replace the queue
mark sensor.
1.
Repeat steps
through
in
“Removing the Printhead” on page 88
.
2.
Remove the queue sensor holder (1) from the printhead holder (2) as described
in the following steps:
a.
Push on the queue sensor holder (1) with your thumb until its
locking tabs (3) move as shown in the following “After push” illustration.
b.
To complete the removal of the queue sensor, grab the plastic body
of the sensor and pull it to remove it from the printhead holder.
3.
Reverse all remaining disassembly steps to complete the reassembly.
4.
Perform the applicable checkout procedures.
Refer to
“Functional Checkout” on page 99
.
Replacing the Mainboard/ETE Module Assembly
The following procedures describe how to replace the mainboard/ETE module
assembly.
Processing ECGs in Internal Storage
Before replacing the mainboard, if the system has the internal storage option, transmit
any ECGs remaining in storage to your archival system and/or print them to ensure
you have a printed record.
Saving System Configuration Settings
System configuration settings are saved on the mainboard. Before replacing the
mainboard, it is very important to save a record of the system configuration settings.
94
MAC™ 1600
2028451-183E
Summary of Contents for MAC 1600
