28
Before a
clean cycle
NOTE:
When the 27
″
oven is set for self-
cleaning, only the surface burners may be
used. The 12
″
oven, the griddle and/or the
grill cannot be used.
For the first self-clean cycle, we recommend
venting your kitchen with an open window or
using a ventilation fan or hood.
Remove the broiler pan, broiler grid, all
cookware, probe and any aluminum foil from
the oven—they cannot withstand the high
cleaning temperatures.
NOTE:
Your oven is equipped with gray
porcelain-coated oven shelves. They may be
left in the oven during the self-clean cycle.
Soil outside the gasket on the front frame of
the range and on the door will need to be
cleaned by hand. Clean these areas with hot
water, soap-filled scouring pads or cleansers
such as Soft Scrub
®
. Rinse well with clean
water and dry.
Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for the gasket
to remain intact. If you notice it becoming
worn or frayed, replace it.
Wipe up any heavy spillovers on the oven
bottom.
Make sure the oven light bulb cover is in place
and the oven light is off.
How to
set oven for
self-cleaning
The clean cycle takes about 5 hours plus about
30 minutes to cool down.
1
Push in the CLEAN selector button on the
right hand side of the control panel above
the thermostat dial.
2
Set the thermostat dial to CLEAN.
• Cooling blower turns on.
• The OVEN light and HEATING light turn on.
• The DOOR LOCKED light turns on.
• The blower and the OVEN light will turn off
once the cycle has finished.
3
When cleaning has finished, push the OFF
selector button.
The door latch will unlock automatically after
the oven temperature falls below approx. 550°F.
Oven Control
Wipe up heavy soil on the oven bottom.
Self-Cleaning 27
″
Oven
Stainless Steel Range
Summary of Contents for Monogram ZDP48N4G
Page 40: ...40 Notes Stainless Steel Range...
Page 41: ...41 Notes Stainless Steel Range...
