The electrode of the
spark ignitor is behind
each burner.
When one
burner is turned to
“ON” to light, all the
burners spark.
Do not
attempt to disassemble
or clean around any burner while another
burner is on. An electric shock may result,
which could cause you to knock over hot
cookware.
32
Sealed
burner
assemblies
Turn all controls
OFF
before removing the
burner parts.
The burner grates, burner caps and burner
ring sub-assemblies can be lifted off, making
them easy to clean.
CAUTION: DO NOT OPERATE THE
BURNER WITHOUT ALL BURNER PARTS
IN PLACE.
MISE EN CAUSE : N’UTILISEZ PAS DE
BRÛLEUR QUI N’A PAS TOUTES SES
PIÈCES EN PLACE.
For proper ignition, make sure the small holes
in the burner rings are kept open. A sewing
needle or wire twist-tie works well to unclog
them.
The slits in the burner heads of your cooktop
must be kept clean at all times for an even,
unhampered flame.
You should clean the surface burner routinely,
especially after bad spillovers, which could clog
these openings.
To remove burned-on food, soak the burner
heads and rings in a solution of mild liquid
detergent and hot water for 20–30 minutes.
For more stubborn stains, use a toothbrush.
Clean the burner bases in place on the
cooktop.
To remove the burner parts:
1
Lift off the burner cap and burner head.
2
Remove the burner ring locking nut using
a 1
1
⁄
16
″
socket wrench, crescent wrench or
channel-lock pliers.
3
Lift off the burner ring.
Do not remove the
burner bases.
Before putting the burner parts back, shake
out excess water and then dry them thoroughly
by setting them in a warm oven for 30 minutes.
To replace the burner parts:
Make sure all parts for the correct burner are
firmly seated.
1
Align the locator pins on the burner ring
into the labeled hole in the burner base.
Seat in place.
2
Replace the burner ring locking nut and
hand-tighten. Using the wrench or pliers,
turn the nut 1/4 turn to secure it in place.
3
Align the locator pin in the burner head into
the hole in the burner ring. Seat in place.
4
Replace the burner caps.
High Output Burners
Use a sewing needle, twist-tie
and/or toothbrush to unclog the
small holes and slits in the burner
heads and burner rings.
To aid reassembly, each brass
Burner Head is marked with a
clock face. Replace the Burner
Head with the arrow pointing to
the rear of the cooktop (12 o’clock
position).
Slits
Holes
Electrode
Burner Head
(Brass)
Burner Base
Burner Cap
Locator Pin
NOTE:
Locator pin fits
into burner base pin slot.
Electrode
Pin
Slot
Locator Pin
Burner Ring
(Aluminum)
Burner Ring
Locking Nut
Care and Cleaning
Stainless Steel Range
Summary of Contents for Monogram ZDP48N4G
Page 40: ...40 Notes Stainless Steel Range...
Page 41: ...41 Notes Stainless Steel Range...
