background image

For answers to your Monogram,

® 

GE Profile

 or  

GE

®

 appliance questions, visit our website at 

geappliances.com or call GE Answer Center

®

 

service, 800.626.2000.

170132

Specification Revised 10/11

ZGG420NBPSS - Natural Gas Built-in Outdoor Grill

ZGG420LBPSS - LP Gas Built-in Outdoor Grill

Dimensions and Installation Information (in inches) 

Outdoor Built-in Cooktop

 

These grills are designed to be installed into a non-
combustible enclousure.
To install into combustible enclosures Built-In 
Monogram Outdoor grills must use Grill Liner 
accessory ZX42JR for 42". Please refer to the  
Grill Liner instructions for the details.

•  The grill drops into the opening and hangs from 

the side flanges. It does not require support from 

the bottom.

•  The cutout must be completely covered with 

non-combustible material such as stone, brick, 

ceramic tile, concrete board, etc. The countertop 
surface and edges must be flat and level.

•  If the countertop has an overhang, it must be 

notched or cut back flush with the front face of 
the cabinet below.

•  Allow at least 12" minimum clearance at the 

back of the grill when the exhaust is directed to a 
window or surface that is difficult to clean. Allow 
at least 4" clearance behind the grill to allow the 
hood lid to open. See notched detail below.

•  Allow 12" minimum clearance on both sides 

and the back of the grill to adjacent vertical 

combustible construction.

•  These gas grills cannot be used below any type of 

overhead construction.

•  These grills are designed for outdoor use only. Do 

not locate the cooktop in a building, garage or 

other enclosed or semi-enclosed area.

•  Locate the backside of the grill away from 

prevailing winds and avoid cooking in windy 

conditions.

41-7/8"

12" Min. to Combustibles

4" Min. Clearance for Lid

to Non-Combustibles

27"

26"

*The weight of the grill is fully supported by

the side trims. The back of the grill overlaps

the back edge of the cutout.

10-1/4" from 

Bottom of 

Support Flange

*25-1/2" 

Countertop Depth

27" to Front

of Control Panel

28-1/2" to Front of Bullnose

40-3/4"

36"

Min.

1-1/8" Min.

10-7/8"

24-1/2"

Grill Cutout

Gas and

Electrical

Locations

Opening 

for Optional 

Access Doors

**  Built-In Monogram Outdoor grills must use 

Grill Liner accessory ZX42JR for 42" Built-in 
to install into combustible enclosures. Please 
refer Grill Liner instructions for the cut-out 
dimensions.

Reviews: