STEP 16 ADJUST DECORATIVE PANELS
- FLUSH INSTALLATION ONLY
(Cont)
5. Make the final vertical adjustment of the door panel.
Using the set screw at the top of the door, turn
clockwise until the desired gap between the grille
panel bottom and top panel of the door appears
satisfactory.
6. Tighten all washer-head screws (NOT SET SCREWS)
firmly to secure brackets and adjustments in place.
Start with bottom edge washer-head screws to
provide support of the door panel. Next, moving on to
top edge to prevent panel from moving from aligned
position. Finish by tightening hinge side washer-head
screws. NOTE: Over-tightening washer-head screws
may result in bending wood panel brackets as well as
misaligning wood door
panels.
7. Drive the door anchor
screws through the
two white plastic pock-
ets in the side of each
door and into the door
panel (4 each door) to
prevent panel warping
over time.
28
Installation Instructions
STEP 17 REPLACE TRIM - FLUSH
INSTALLATION ONLY
1. Replace trim and 6 screws on hinge side of the door.
2. Replace handle visor trim and four screws on the han-
dle side of the door.
3. Replace trim cover and four screws over visor trim on
the handle side of the door.
Turn set screws on top and bottom
of door to move panel up or down
for desired gap with grille panel
bottom.
Hinge side
trim
Handle
visor trim
Handle
side trim
Summary of Contents for Monogram ZIRS360NNLH
Page 30: ...Notes 30...
Page 31: ...Notes 31...
