GE Monogram ZIRS360NNLH, Installation Instructions Manual

Design Guide

7

These units are equipped with a 3-position door stop. 
The factory set 115° door swing can be adjusted to 90° 
or 130° if clearance to adjacent cabinets or walls is 
restricted. Order WX14X99 door stop for precise settings 
between 90° and 130°.

When Installed into a corner:
Allow 25” for a full 130° door swing. Allow 15” for pan 
removal. Allow 4” min. clearance when door swing  
is adjusted to a 90° opening for pan access, but pan 
removal is restricted.

25"

Min. to

Wall

130

°

130

°

 Door

Swing

CLEARANCES FOR STANDARD INSTALLATION AND STAINLESS MODELS ONLY

ZUG2, ZUGSS2 Unified Grille Panel Kit

• If you are installing two units, side by side,  

the installation space must be 71-1/2” wide.

Note: Additional cutout width may be required when 

side panels are used. Add side panel thickness  

to the finished cutout to calculate rough-in width.

•  The water and electrical locations for each product 

must be located as shown.

•  A separate 115V, 60Hz., 15 or 20 amp power supply  

is recommended for each product.

Clearances for Multiple Single Door Installations  
In a side-by-side installation of a left and right door 
swing product, a 1” clearance between the units is 
required. Order ZUGSS2 Stainless Steel Unified Grille  
Panel Kit or ZUG2 Custom Panel Unified Grille Panel Kit 
for one continuous grille panel.

Clearances for two products installed side-by-side 
with the same (left or right) door swing 
Allow 2” minimum clearance between the products  
to prevent door swing interference. Order the WX14X99 
adjustable door stop to reduce the factory set 115°  
door swing. Allow 15” minimum to a wall to achieve  
full drawer extension and pan removal.
NOTE: ZUG2 and ZUGSS2 Grille Panel Kit will NOT fit this 
installation.

2"

15"

Clearances for two products installed side-by-side 
with right and left side hinges together 
Allow 5” minimum between the two products to prevent 
one door from striking the other. Use the WX14X99 
adjustable door stop to reduce the factory set 115°  
door swing and to allow pan removal.
NOTE: ZUG2 and ZUGSS2 Grille Panel Kit will NOT fit this 
installation.

5"

INSTALLATION FOR STANDARD AND 

STAINLESS MODELS ONLY