4
Design Information
36" Stainless Steel Refrigerators, Freezers
Side By Side
Installation
Of Freezer
And Refrigerator
For a complete food storage center, install a Monogram
Freezer and Refrigerator side by side. For even more
capacity, install two refrigerators and one or two freezers.
• Order ZUGSS Unified Grille Panel Kit for one
continuous stainless steel grille panel.
• Electrical and water locations must be located as
shown for either type of installation. A separate
115V, 60Hz, 20 amp power supply is recommended
for each product.
Installation
Between
Base and
Wall Cabinets
NOTE:
1/4" thick side panels can be inserted
into the case trim, making the rough-in the
same as the outside trim width: 36”.
*72" min. for a flush installation
71-1/2" min. for a semi-flush installation
NOTE:
Additional cutout width may be required when side
panels are used. Add side panel thickness to the finished cutout
to calculate rough-in width. See installation examples below.
Side panels are required whenever the sides of the
product will be exposed.
1/2" to 3/4" side panels are normally set into place and
fastened to adjacent cabinetry or to the back wall before
rolling the refrigerator or freezer into the opening.
Therefore, the rough-in dimensions must allow for
side panel thickness. In both a flush and semi-flush
installation, the finished dimension (the width of
the opening after side panels are installed) must
accommodate the full width of the product.
See page 10 for side panel sizes.
Installation
Examples
Refrigerator or Freezer
1/4" Thick
Side Panels
35-1/2"
Finished Dim.
36"
Rough-In Dim.
Cabinet
Refrigerator door
Refrigerator
Cabinet
These models are factory set for 84" installation height.
Adjustments to 83-1/2" or 84-1/2" heights can be made
by changing the grille panel.
Order ZGCSS36RH
(right hand) or
ZGCSS36LH
(left
hand) Grille Panel Kit. These kits include 2 grille panels,
for 83-1/2" and 84-1/2" installation heights.
Accessory
Grille Panel
Kits
ZUGSS Unified Grille Panel Kit
For side by side installation, order ZUGSS grille panel
kit. This kit provides one continuous panel to span the
width of two products installed together for a unified
appearance.
2 1/2"
75" From Floor
to Bottom
of Electrical
Area
84 1/2" max
83 1/2" min
Finished
Opening
*Finished Width
Electrical
5"
5"
3 1/2"
24 3/4" Total
Depth
Water Supply
Wall View
6"
5"
6"
28 1/2"
26"
Freezer
Refrigerator
