4. On Unit 2, use top and center holes to locate the foil heater. There is a hole in the foil heater. This lines up with the
hole at the center of the case. The "V" notch at the top of the heater, lines up with the top hole in the side of the
case. Remove paper backing from heater and carefully apply heater using these two holes as guides.
5. In front of cabinet enclosure, move units next to each other, whith holes lined up. Make sure heater wire is dressed
towards front of units for use in a later step. Tape heater lead wires to side of Unit 2 so that leads are sticking out
the front, below clip 6, and easily reached for use in a later step. Using bolts, washers and nuts, join the two units
together at the front - top and center. Tightened bolts until spacer clips touch Unit 2.
Rear
Front
Unit 2
Unit 1
Unit 2
Heater lead wires
3
