CHAPTER 5: THE CLI AND PROTOCOL MONITOR
THE CLI AND PROTOCOL MONITOR
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
5–23
5.2.2.13 The system Command
The table below explains the commands available for basic system information
management when the
MN4(system)#
prompt is displayed or from the
MN4#
prompt
using a
system
prefix.
For example:
MN4#
s
ystem set location North Andover
or
MN4(system)#
show
For more information see the description of basic system information management in
section 4.2.2: System Information
.
5.2.2.14 The terminal Command
The table below explains the commands available for terminal settings when the
MN4(terminal)#
prompt is displayed or from the
MN4#
prompt using a
terminal
prefix.
These commands enable you to control the display of CLI command output in your virtual
terminal window.
For example:
MN4#
terminal set lines 18
or
MN4(terminal)#
show
Table 5–15: CLI system Commands
Command
Synopsis
Description
set
set name | location
| contact
The available parameters are:
•
name sysname
– Where
sysname
is a name for the
system under configuration.
•
location placename
– Where
placename
is the
name of the place where the system under
configuration is located.
•
contact identinfo
– Where
identinfo
is a name
or contact information for a person responsible
for management of the system under
configuration.
show
show addresses
Display basic system information.
