3–8
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
ENERVISTA MULTINET4 SETUP SOFTWARE
CHAPTER 3: ENERVISTA MULTINET4 SETUP SOFTWARE
3.6
Port Setting
Ethernet port setting
:
1.
Ethernet setting window will open by clicking the Ethernet under
Setting >
Ports
as shown below.
2.
The system IP address, subnet mask and gateway address of the Multinet4
can be configured on this screen.
Note
The Multinet4 has to be re-configured in the device setup whenever the IP details are
configured from Ethernet Setting screen)
3.
Also the Media, Flow control, Link Loss Handling and the administrative state
for each Ethernet ports can be configured on this screen.
4.
Make sure to click the
Save
button to make the change permanently.
Note
Please refer to Chapter 4 in this manual for advanced setting for Ethernet Ports.
Serial Port Setting
:
1.
Serial port setting window will open by clicking the Serial under Setting ->
Ports as shown below.
2.
The serial interface type and COM setting such as Baud Rate, DataBits,
StopBits, Parity, and Flow Control for each serial port can be configured on this
screen.
3.
The Packet Character, Packet Time, Max packet size and Turnaround Time for
each serial port can be configured on this screen.
4.
Also, the Modbus TCP port number and administrative state for each serial
port can be configured on this screen.
5.
Make sure to click the
Save
button to make the change permanently.
