Connecting an Alarm
4.
Connect Relay/2 to the positive contact of an output connection (e.g.,
“Out1”) in the Activators terminal block.
5.
Connect Relay/3 to the alarm.
6.
Connect the other side of the alarm to the positive (+) power.
7.
Connect the negative (-) power Relay/4.
8.
Connect Relay/4 to the right (-) contact of the output connection (e.g.,
“Out1”) in the Activators terminal block.
9.
Connect the left (-) contact of the 12VDC Power Out connector to the
same right (-) contact of the output connection (e.g., “Out1”) in the
Activators terminal block.
Figure 8 – Connecting an alarm to the IVG-400, release 1
IVG-400 Installation Instructions
Page 6 of 7
Connecting an Alarm in Release 2
To connect an alarm to a release-2 unit, which has a built-in relay:
1.
Install the alarm in its desired location in the vehicle.
2.
Connect the alarm to the Activators terminal block on the rear panel of
the IVG-400 (see
Figure 1
, page 1) as follows (see Figure 9):
•
Connect the positive (+) power to the alarm.
Alarm
+
12V Power
-
Out1 Out2
+
- +
-
+
-
12VDC
Power Out
12VDC
1
Relay
2
4
3
IVG-400
rear panel
Activators
terminal block
