2
49-50327
Performance Data Sheet
MWF Filtration System—GE Appliances MWFA Cartridge
Ŷ6\VWHPWHVWHGDQGFHUWLILHGE\,$3025 7DJDLQVW16)$16,6WDQGDUGDQG6WDQGDUGIRUWKHUHGXFWLRQRIFODLPVVSHFLILHGEHORZDQG
at iapmort.org. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal
to the permissible limit for water leaving the system, as specified in NSF/ANSI 42 and 53.
Ŷ$FWXDOSHUIRUPDQFHPD\YDU\ZLWKORFDOZDWHUFRQGLWLRQV
It is essential that the manufacturer’s recommended installation, maintenance and filter replacement requirements be carried out for the product to perform as
advertised. See Installation Manual for Warranty information.
Application Guidelines/Water Supply Parameters
Service Flow
0.5 gpm (21.9 lpm)
Water Supply
Potable Water
Water Pressure
40-120 psi (2.8-8.2 bar)
Water Temperature
33°F-100°F (0.6°C-38°C)
Note:
While the testing was performed under standard laboratory
conditions, actual performance may vary. Contaminant reduction
testing is conducted every five years by certifying agency to
maintain certification.
Replacement Cartridge: MWFA. For estimated costs of
replacement elements please call 1.877.959.8688 or visit our
website at www.geapplianceparts.com.
WARNING
To reduce the risk associated with ingestion of contaminants:
•
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before and
after the system.
Systems certified for cyst reduction may be
used on disinfected water that may contain filterable cysts.
NOTICE
To reduce the risk associated with property damage due to
water leakage:
•
Read and follow
use instructions before installation and use of
this system.
• Installation and use
must
comply with all state and local
plumbing codes.
•
Do not
install if water pressure exceeds 120 psi (8.2 bar). If your
water pressure exceeds 80 psi, you
must
install a pressure-
limiting valve. Contact a plumbing professional if you are
uncertain how to check your water pressure.
•
Do not
install where water hammer conditions may occur. If
water hammer conditions exist you
must
install a water hammer
arrester. Contact a plumbing professional if you are uncertain
how to check for this condition.
•
Do not
install on hot water supply lines. The maximum operating
water temperature of this filter system is 100º F (38º C).
•
Protect filter from freezing.
Drain filter when temperatures drop
below 33ºF (0.6ºC).
• The disposable filter cartridge
should
be replaced every
6
months at the rated capacity, or sooner if a noticeable reduction
in flow rate occurs.
Capacity 300 Gallons (1,135 Liters).
Substance Reduction
NSF/ANSI specified
Challenge Concentration
Max Permissible Product
Water Concentration
Avg %
Reduction
Chlorine Taste and Odor
2.0 mg/L ± 10%
N/A
97.4%
Nominal Particulate
&ODVV,WRP
At least 10,000 particles/mL
N/A
99.9%
Cyst*
Minimum 50,000 cysts/L
N/A
99.99%
Atrazine
0.009 mg/L ± 10%
0.003 mg/L
99.5%
Lead @ pH 6.5
0.15 mg/L ± 10%
0.010 mg/L
99.3%
Lead @ pH 8.5
0.15 mg/L ± 10%
0.010 mg/L
99.3%
Lindane
0.002 mg/L ± 10%
0.0002 mg/L
96.5%
Mercury @ pH 6.5
0.006 mg/L ± 10%
0.002 mg/L
95.7%
Mercury @ pH 8.5
0.006 mg/L ± 10%
0.002 mg/L
87.6%
*Based on the use of Cryptosporidium parvum oocysts.
MWFA System is certified by IAPMO R&T against
NSF/ANSI Standards 42 and 53 for the
reduction of claims specified on the performance
data sheet and at iapmort.org.
The contaminants or other substances removed or reduced by this
water filter are not necessarily in all users’ water.
