11
1. Enter a valid user code.
2. The red armed light will go off and
the tone will stop. The security system is now DISARMED. If a valid code is
not entered before the end of the entry delay, an alarm will occur. NOTE: If
the red armed light is flashing during the entry delay, the alarm system
has been activated in your absence. Leave the building immediately and
call your alarm company and/or the police from a safe location.
IV.
CANCEL / ABORT FEATURE
(Optional if programmed)
The cancel light will flash during an abort delay time. If a code is entered followed by
CANCEL while this light is flashing, all abortable reports will stop the communication
process. NOTE: The abort feature must be enabled. Entering a code followed by
CANCEL during or after an alarm report to the central station will cause the cancel light
to come on. It will stay on until the central station has received the cancel report. NOTE:
The cancel feature must be enabled.
V. BYPASSING
ZONES
If you wish to bypass one or more zones, this must be done while the system is in the
disarmed state. If the zone is not known, refer to Procedure #2.
PROCEDURE #1: If you know the number of the zone to bypass, use the following:
1.
Press BYPASS.
2.
When the LCD prompts for a code (optional, if programmed), enter your user
code.
3.
The bypass light flashes.
4.
Enter the zone you wish to bypass. (Example:
]
for zone 6 or
X
X
Y
for zone 112.)
5.
Press BYPASS again. The zone is now bypassed.
7\SHFRGHWR
'LVDUP
Summary of Contents for NetworX NX-1192E
Page 1: ...NX 1192E LCD Keypad User s Manual ...
Page 33: ...31 ...
Page 34: ...32 SYSTEM NOTES ...
Page 35: ...NX1192E USERS MANUAL NX1192EUB02 REV B 10 10 02 ...
