GE NetworX NX-1500E, User Manual

BYPASSING ZONES 
If you wish to bypass one or more zones,  this  must  be  done  while  the 

system is in the disarmed state. The following steps are used for bypassing 

zones: 

Step 1 

Press the [BYPASS] key. 

Step 2 

Enter user code, if required (optional).  The bypass light flashes. 

Step 3  Enter 1 or 2 digits indicating the zone you wish to bypass, i.e. 

press the [1] key for zone 1, press [1]-[2] for zone 12. 

Step 4 

Press the [BYPASS] key again. 

Step 5 

The  corresponding  zone light will illuminate indicating the zone 

has been bypassed.  Repeat steps 3 and 4 for any other zone(s) 

that need to be bypassed. 

Step 6 

Press the [BYPASS] key again  -or- press the [#] key to exit the 

Bypass Mode. The bypass light will stop flashing upon exiting the 

Bypass Mode. 

 
GROUP BYPASS 
By pressing the [BYPASS] key, followed by the [0] key, then the [BYPASS] 

key again, all zones that are designated as group bypass zones will be 

bypassed. Press the [BYPASS] key again to exit group bypassing. 

 
UNBYPASSING 
To manually unbypass zones, perform the bypassing procedure on a zone 

that is already bypassed. The corresponding light for that zone will go off 

when unbypassed. NOTE: All zones will automatically be unbypassed 

each time the system is disarmed. 

 
TURNING THE DOOR CHIME ON AND OFF 
The door chime is turned on or off by pressing the [CHIME] key while the 

system is in the disarmed state. If the chime is on the chime light will be 

illuminated. If the chime is off, the chime light will be off.  Each press of the 

[CHIME] key will toggle the chime feature on/off and produce a momentary 

ding-dong sound. 

Page 12