GE NetworX NX-1500E, User Manual

ADDING AND CHANGING USER CODES 

Your system must be Disarmed to change user codes. 

Step 1  Press [

r

]-[5]-[“Master Arm/Disarm” Code]. 

NOTE:  For partitioned systems, someone changing the code of 

another person must have access to all or more partitions 

than the user being changed. 

Step 2  The ready light will flash. 

Step 3  Enter the 2 digit “user number” (always enter 2 digit such as [0]-

[3] for user 3, or [5]-[2] for user 52). 

Step 4  The zone lights will illuminate specifying the first digit of the “user 

code”.  (Lights 1-8 on = code is blank, lights 1-8 off = “0”, lights 1 

and 8 = “9”).   

NOTE: To delete a user code, enter [

r

]-[

r

]-[

r

]-[

r

] for a 4-digit code, or 

[

r

]-[

r

]-[

r

]-[

r

]-[

r

]-[

r

] for a 6-digit code. 

Step 5  The ready light will flash indicating you are back at Step 2 above. If 

the code is rejected, the sounder will beep 3 times. 

Step 6  If another “user code” needs to be programmed, return to Step 3. 

Step 7  Press the [#] key while the ready light is flashing to exit the User 

Code Programming Mode. 

ASSIGNING USER CODE AUTHORITY LEVELS 

Assign authority levels to users by following the steps below.  Assign user 

codes before assigning authority levels. 

Step 1  Press [

r

]-[6]-[“Master Arm/Disarm Code”]. 

NOTE:  Someone changing the authority of another person can only 

add or remove partition authorization for partitions to which 

they have access. 

Step 2  The ready light will flash. 
Step 3  Enter the 2 digit “user number” to be assigned authority (The ready 

light is constant and the instant light will flash). 

Step 4  Lights illuminated indicate the authority levels assigned to this 

code.  An explanation of the lights is listed in the following table. 

Page 13