GE NetworX NX-1500E, User Manual

OTHER KEYPAD FUNCTIONS 

SETTING THE KEYPAD TONE   
Step 1 

Press [

r

]-[0].  Keypad is now in the “Adjust Tone” mode.   

Step 2 

Pressing the [1] key will make the keypad sounder go to higher 

tones, pressing the [2] key will make the keypad sounder go to 

lower tones.  

Step 3 

When the desired tone is reached, press the [#] key to set this 

tone and exit from the “Adjust Tone” mode. 

 
CHANGE PARTITION – Optional 
Step 1 

Press [

r

]-[1]. 

Step 2  Press a NUMBER key between 1 and 8 to change partitions 

momentarily.   

Step 3 

If no other key is pressed, it will go back to its standard partition 

in ten seconds.  

Step 4  If another key is pressed, the system will remain in the new 

partition until no keys have been pressed for 60 seconds. 

VIEW ALARM MEMORY 
Step 1 

Press  [

r

]-[3].   The zone(s) that created the last alarm will be 

displayed on the keypad.  

Step 2 

The ALARM MEMORY feature will flash those zones that created 

alarms and will light steady those zones that were bypassed 

during the last alarm. 

TEST FUNCTION – Optional 
If programmed, this function will perform a battery test, communicator test, 

and/or a siren test. Alarms and reports will not be sent, unless a 

communicator test is performed at which time a test signal will be sent. 

Step 1 

Press [

r

]-[4].  The test will be performed as programmed. 

Step 2 

If the siren test is performed, enter a user code to silence the 

siren. 

Page 15