NX-148E-RF LCD Touchpad with Receiver
Installation Instructions
8
Call back for download (98)
To cause the control to do a call back for download (while the
system is disarmed), enter
* 98
.
Seize phone line for download (99)
To cause the control to seize the phone line for a download
(while the system is disarmed), enter
* 99.
Walk test (CHIME)
The walk test allows you to walk through to test the zones (while
the system is disarmed). To do a walk test, do the following:
1.
Enter
* CHIME
.
2.
Enter your user code.
3.
Walk through the zones. Each time a zone is faulted, it will
be displayed on the touchpad and a chime will sound.
4.
The walk test mode will exit after 15 minutes, or you can
enter your user code to exit at anytime.
Silent exit (EXIT)
To silence the exit beeps during exit delay (while the system is
disarmed), do the following:
1.
Enter
* EXIT
.
2.
Enter your user code.
3.
To exit, press #.
Reference tables
Table 9.
Service menu messages
Message
Explanation
Control over current
A short circuit of a power supply has occurred.
Control siren trouble
Open circuit on the bell or siren circuit.
Control box tamper
(Optional) The box tamper circuit has activated.
Control phone trouble
The phone line connected to the control is not
operating properly.
Control fail to comm.
The control made an unsuccessful attempt to
communicate a message to the central station.
Control ground fault
A short to ground has been detected on a
control circuit.
Control loss of time
Your system has lost total power and needs the
clock reset.
Control power trouble
The main power to the system is off.
Control low battery
The standby battery is low.
Expansion aux comm
fail
A auxiliary reporting device (i.e. NX-580E, NX-
582E, etc.) has failed to communicate.
Expansion over current
A short circuit of an expansion devices power
supply has occurred.
Expansion power
trouble
The main power to an expansion power supply
is off.
Expansion low battery
An expansion power supply has a low battery.
Expansion box tamper
A box containing an expansion device has been
opened.
Expansion RF jammed
A radio receiver is being jammed.
Expansion trouble
An expansion device or touchpad is not
reporting to the control panel.
Expansion siren trouble
An expansion device has detected trouble on
the bell or siren circuit.
Zone tamper, press *
A zone is tampered. Press * to identify the
tampered zone.
Zone low battery,
press *
A wireless device has a low battery. Press * to
identify the zone.
Zone lost, press *
A wireless or multiplexed zone device is not
reporting to the control. Press * to identify the
zone.
Zone trouble, press *
A zone is experiencing trouble. Press * to iden-
tify the zone.
