Chapter 5. Diagnostics
GFK-2571N
May 2018
119
Group/
Category/
Type/
Descriptor
Description
Cause
Recommended
Correction
3-35-0-0
Loss of network
port on PROFINET
device.
A configured network port
on the PROFINET device is
no longer present.
Repair or replace the missing or
malfunctioning network port on the
device.
3-35-1-0
Expected SFP is
missing.
SFP configured for a port on
the PNC001 module is not
physically present.
Insert SFP into port of PNC001 to
match configuration stored to the
PNC001 or remove the SFP from PME
configuration.
3-35-2-0
PROFINET Device’s
network port under
control of
PROFINET
Supervisor.
A PROFINET Supervisor has
taken control of a
PROFINET device’s network
port, for which the
PROFINET Controller is
currently configured and to
which it is connected.
If this is unexpected operation,
investigate reason for Supervisor
taking control.
3-68-1-0
Unsupported SFP
detected.
An unsupported (non-
Ethernet) SFP is physically
connected to a PNC001
port.
The installed SFP is not supported,
replace with supported SFP
3-68-2-0
Invalid SFP
detected.
An invalid (non-functional)
SFP is physically connected
to a PNC001 port.
The installed SFP is invalid, replace
with a supported SFP
7-3-0-0
Addition of Device.
A configured PROFINET
device that was previously
missing has just been re-
connected.
None.
Note:
In an MRP ring with a large
number of clients, storing a
configuration that causes all clients to
reconfigure (for example, changing
the
Domain Name
) may generate a
large number of Loss/Addition of
Device faults. This is expected
behavior and all devices should
automatically return to operational.
7-15-0-0
Addition of
Submodule
A configured PROFINET
submodule that was
previously reported lost has
just been added to the
device.
None.
7-15-1-0
Submodule
released by
PROFINET IO
Supervisor
A configured PROFINET
submodule that was
previously controlled by a
PROFINET IO Supervisor
has just been released.
None.
7-31-1-0
Extra SFP present
on the PNC001.
An SFP port on the PNC001
module has been
configured to be empty, but
an SFP is present.
Either update the PNC001
configuration to indicate the SFP is
present, or physically remove the
extra SFP from the PNC001 port.
