Chapter 7. Network Management
148
PACSystems* RX3i & RSTi-EP PROFINET IO-Controller User Manual
GFK-2571N
7.2.3.7
PROFINET Chassis MAC TLV
The PROFINET Chassis MAC indicates the internal MAC address used by the PROFINET stack. This is not the
MAC address of any individual network port.
7.2.3.8
MAC/PHY Config/Status TLV
The MAC/PHY Configuration/Status indicates the supported auto-negotiation capability, the current
negotiated capability, and the Medium Attachment Unit (MAU) type of the network port over which this LLDP
message is sent.
Field
Values
RX3i PROFINET Controller
Auto-
negotiation
Support/Status
Bit 0: Auto-negotiation supported (1= Yes, 0 = No)
Bit 1: Auto-negotiation status
(1 = Enabled, 0 = Disabled)
Bits 2-7: Reserved
0x03 (Auto-negotiation
supported and enabled)
Auto-
negotiation
Advertised
Capability
Note: There are no AutoNegCapability definitions for
100Base FX or LX (HD or FD). A device that supports
these must advertise “Other”.
Copper Ports:
0x6C03 = 10/100/1000T HD+FD
SFP Ports:
(Depends on SFP type)
0x000C = 1000 LX/SX HD+FD
0x6C03 = 10/100/1000T HD+FD
0x8000 = Other (100 FX, LX)
SC Fiber Ports:
0x8000 = Other (100 FX)
Operational
MAU Type
Typical values are:
0x000B: 10BaseT FD
0x0010: 100BaseTX FD
0x0012: 100Base FX FD (Multi-mode fiber)
0x0018: 1000BaseLX FD (Long wavelength fiber)
0x001A: 1000BaseSX FD (Short wavelength fiber)
0x001E: 1000BaseT FD (Copper)
Copper Ports:
0x001E = 1000T, FD
SFP Ports:
(Depends on SFP type)
0x0012 = 100 FX, LX
0x0018 = 1000 LX, FD
0x001A = 1000 SX, FD
0x001E = 1000 T, FD
SC Fiber Ports:
0x0012 = 100 FX, FD
