8
49-1000702 Rev. 1
REFRIGERATOR LOCATION
•
'RQRWLQVWDOOWKHUHIULJHUDWRULQDORFDWLRQH[SRVHGWRZDWHUUDLQHWFRUGLUHFWVXQOLJKW
• Install it on a floor strong enough to support it fully loaded.
•
7KLVUHIULJHUDWRULVGHVLJQHGWRIXQFWLRQSURSHUO\LQURRPWHPSHUDWXUHVUDQJLQJIURP)&WR)
&2SHUDWLQJWKHUHIULJHUDWRULQURRPWHPSHUDWXUHVRXWVLGHWKLVUDQJHZLOOFDXVHLQDGHTXDWHFRROLQJ
• This refrigerator is designed for built-in application. Air clearances for sides, top and back are not required.
,QVWDOODWLRQGLPHQVLRQVZLGWK´GHSWK´KHLJKW´
Installation
Instructions
PBV10
REVERSING THE DOOR SWING
WARNING
)ROORZDOOVWHSVZKHQUHYHUVLQJWKH
GRRUVZLQJ)DLOXUHWRIROORZWKHVHLQVWUXFWLRQVOHDYLQJ
off parts, or overtightening screws, can lead to the door
falling off and result in injury and property damage.
WARNING
To reduce the risk associated with choking, do not allow children under 3 years of age to have
access to small parts during the installation of this product.
7KLVSURGXFWDOORZVGRRUVZLQJUHYHUVDO.HHSDOO
hardware and screws in this process for reinstal-
lation. Make notes of screw location during this
process for proper reinstallation.
This section demonstrates the process of changing
IURPULJKWGRRUVZLQJWROHIWGRRUVZLQJ'RRUVZLQJ
reversal from left to right can be done following the
same process.
Locate these parts in the Owner’s Manual bag:
PARTS REQUIRED BUT NOT PROVIDED:
Top Mounting Bracket
Left side upper
hinge cover
Left side
upper hinge
Left side
IUHH]HUGRRU
stopper
Removing Upper Hinge
7DSHUHIULJHUDWRUDQGIUHH]HUGRRURQERWKOHIWDQG
right side to hold doors in place.
2. Remove the upper hinge cover.
8VHDPPVRFNHWZUHQFKWRUHPRYHWKHIRXU
screws that secure the upper hinge, then remove the
upper hinge.
.HHSWKHUHPRYHGXSSHUKLQJHFRYHUDQGXSSHU
hinge for future door swing reversal.
4. Tuck sensor into the sensor enclosure.
5. Remove the screw cover from left side where the
upper hinge will be installed and install the cover
onto right side.
6. Remove tape on refrigerator door. Hold the door
in place with one hand, depress door lock paddle
with the other hand to clear the lock bracket on the
mullion. Gently pull the door upward off the middle
hinge to remove the door and carefully put it aside.
TOOLS REQUIRED
Phillips
screwdriver
)ODWKHDGVFUHZGULYHU
Ratchet Wrench with
PPDQGPPVRFNHWV
INSTALLATION INSTRUCTIONS
Screw Cover
Sensor Enclosure
