24
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
Using the Self-Cleaning Oven
The oven door must be closed and all controls must be set correctly for the cycle to work properly.
How to Delay the Start of Cleaning
Touch
SELF CLEAN
.
For double oven models only,
touch
UPPER OVEN
or
LOWER OVEN
to select
the desired oven.
Three self clean time options are
available:
■
LIGHT CLEAN
– Touch for an
automatic 3-hour clean time.
Recommended for use when cleaning
small, contained spills.
■
REGULAR CLEAN
– Touch for
an automatic 5-hour clean time.
Recommended for a dirtier oven.
■
CUSTOM
– Touch and, using the
numbers, set a clean time between
3 hours and 7 hours and 30 minutes,
depending on how dirty your oven is.
Touch
LATER
.
Three delay start time setting options
are available:
■
DELAYED TIME
– Touch and then use
the numbers to set the amount of
time before you want cleaning to start.
Touch
ENTER
.
■
START CLEAN TIME
– Touch and then
use the numbers to set the time of day
you want cleaning to begin. Touch
ENTER
.
■
FINISH CLEAN TIME
– Touch and
then use the numbers to set the
time of day that you want cleaning
to finish. Touch
ENTER
.
The door locks automatically. The screen will
show the start time. It will not be possible to
open the oven door until the temperature
drops below the lock temperature and
OVEN
LOCKED
goes off.
When
OVEN LOCKED
goes off, you will be able
to open the door.
On double oven models, you can set a clean in both
ovens at the same time. The second oven set will
automatically delay the start of cleaning until the end
of the first oven’s clean cycle or until the delay time
that you set.
To set the second oven, there are two options
available:
■
Immediately after setting the first oven:
Select
PRESS TO MAKE LOWER OVEN
SELECTIONS
or
PRESS TO MAKE UPPER
OVEN SELECTIONS
as needed and follow
steps 3–6 above for the second oven.
■
From the home screen:
Touch
SELF CLEAN
.
Touch
LIGHT CLEAN, REGULAR CLEAN
or
CUSTOM
. See above for reference.
Touch
START AFTER 1ST SELF CLEAN
for
the second oven to automatically start
cleaning after the first oven has finished
cleaning or
DELAYED TIME
and follow
step 6 above to set the time you want the
second oven to start.
To recall the remaining time or the start time set,
touch
SELF CLEAN
.
■
To stop a clean cycle, touch
CANCEL
or the
CLEAR/OFF
pad. When
OVEN LOCKED
goes
off, indicating the oven has cooled below
the locking temperature, you will be able
to open the door.
OR
U
PPER
O
VEN
L
OWER
O
VEN
S
ELF
C
LEAN
After a Clean Cycle
You may notice some white ash in the oven.
Wipe it up with a damp cloth after the oven
cools.
If white spots remain, remove them with a soap-filled
steel-wool pad and rinse thoroughly with a vinegar and
water mixture. These deposits are usually a salt residue
that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
■
You cannot set the oven for cooking until
the oven is cool enough for the door to
unlock.
■
While the oven is self-cleaning, you can
touch
CLOCK
to display the time of day.
To return to the clean countdown, touch
SELF CLEAN
.
■
If the racks become hard to slide, wipe the
rack supports with cooking oil.
On double oven models only.
L
IGHT
C
LEAN
OR
R
EGULAR
C
LEAN
C
USTOM
OR
0
9
8
7
6
5
4
3
2
1
OR
L
ATER
E
NTER
0
9
8
7
6
5
4
3
2
1
S
TART
C
LEAN
T
IME
D
ELAYED
T
IME
OR
F
INISH
C
LEAN
T
IME
(Numbers will only be used when
setting a CUSTOM clean time.)
Summary of Contents for PCT920
Page 46: ...46 ...
