– 38 –
3. Tilt the bottom of the drawer out and lift the
drawer off the rail assembly.
4. Place the drawer front on a protected surface.
8. Lift the bottom of the cover up and pull cover
towards the front of the refrigerator.
9. Disconnect the 3 freezer evaporator cover
component harnesses.
Disconnect
Disconnect
Disconnect
Lock Tab
Note:
Behind the cover there is a recessed area in
the back wall that houses the evaporator assembly.
The cover is held in place by 2 recessed Phillips-
head screws and 3 tabs inserted into the bottom of
the recess.
7. Remove the 2 recessed Phillips-head screws
that attach the cover to the back wall of the
freezer compartment.
5. Using
a
fl
at blade screwdriver, press in the rail
lock tab on the left side rail cover then slide the
rail out slightly to cover the lock tab. Repeat this
procedure on the right-side rail.
6. Evenly pull the rail assembly away from the
refrigerator until both rails are clear of the
cabinet.
