– 63 –
(
Continued next page
)
3. Grasp the mullion and pull it vertically upward
to release it from the top and bottom retainers.
4. Pull out and disconnect the wire harness.
Disconnect
To disassemble the mullion assembly:
Remove the articulating door mullion assembly.
1.
(See
To remove the articulating door mullion
assembly
.)
Caution:
In the following step, care must be taken to
prevent breakage of the door closure cover and/or
door closure hinge.
Remove the door closure spring by pulling the
2.
top arm of the spring down and out of the door
closure cover.
Lift the spring out of the door closure hinge.
3.
Note:
Be sure the spring sleeve is placed in the door
closure cover before installing spring.
Note:
The door closure support is held to the door
closure cover with 13 tabs.
4. Using a putty knife or similar tool, carefully pry
and lift the door closure support from the door
closure cover.
Spring
Sleeve
Door Closure
Cover
Door Closure
Support
