GE Profile 24 CustomStyle, Owner'S Manual And Installation Instructions

8

About the dispenser.

 (on some models)

Press the glass gently against the dispenser cradle.
The spill shelf is not self-draining. To reduce water spotting, the 

shelf should be cleaned regularly.
If no water is dispensed when the refrigerator is first installed, 

there may be air in the water line system. Press the dispenser 

paddle for at least five minutes to remove trapped air from the 

water line and to fill the water system. To flush out impurities in 

the water line, throw away the first six full glasses of water.

WARNING

Laceration Hazard

„

 Never put fingers or any other object into ice crusher 

discharge opening. Doing so can result in contacting the ice 

crushing blades and lead to serious injury or amputation

„

 Use a sturdy glass when dispensing ice. A delicate glass may 

break and result in personal injury.

To remove Dispenser Tray

„

 Pull Dispenser Tray out.

To reinstall Dispenser Tray

„

 Push in until it is firmly in place.

Door Ice Bin

1. Open left fresh food door.
2. Pull down latch to release bin 

door.
3.   Using handhold,  lift ice bucket 

up and out to clear locators in 

bottom of bin.

4.  To replace the ice bucket, set 

it on the guide brackets and 

push until the ice bucket seats 

properly.

5.  If bucket cannot be replaced, 

rotate the Ice Bucket Fork 1/4 

turn clockwise.

Water & Ice Dispenser

(See About the controls)

Internal Water Dispenser  

(on some models)

The water dispenser is located on the left wall inside the 

refrigerator compartment.
To dispense water:
1. Hold the glass against the recess.
2. Push the water dispenser button.
3.  Hold the glass underneath the dis-

penser for 2–3 seconds after releas-

ing the dispenser button. Water may 

continue to dispense after the button 

is released.

If no water is dispensed when the 

refrigerator is first installed, there may be air in the water line 

system. Press the dispenser button for at least 5 minutes to 

remove trapped air from the water line and to fill the water 

system. During this process, the dispenser noise may be loud 

as the air is purged from the water line system. To flush out 

impurities in the water line, throw away the first 6 glassfuls of 

water.
NOTE: To avoid water deposits, the dispenser should be 

cleaned periodically by wiping with a clean cloth or sponge.

Important Facts About Your Dispensers

„

 Do not add ice from trays or bags to the door ice maker  

bucket. It may not crush or dispense.

„

 Avoid overfilling glass with ice and use of narrow glasses. 

Backed-up ice can jam the chute or cause the door in the 

chute to freeze shut. If ice is blocking the chute remove the ice 

bucket, poke it through with a wooden spoon.

„

 Beverages and foods should not be quick-chilled in the  

door ice maker bin. Cans, bottles or food packages in the 

storage drawer may cause the ice maker or auger to jam.

„

 To keep dispensed ice from missing the glass, put the glass 

close to, but not touching, the dispenser opening.

„

 Some crushed ice may be dispensed even though you 

selected CUBED ICE. This happens occasionally when a few 

cubes accidentally get directed to the crusher.

„

 After crushed ice is dispensed, some water may drip from the 

chute.

„

 Sometimes a small mound of snow will form on the door in the 

ice chute. This condition is normal and usually occurs when you 

have dispensed crushed ice repeatedly. The snow will eventually 

evaporate.

Dispenser 
Tray

Ice bucket 

fork

Latch

Ice bucket