WARNING:
The neutral or ground wire
of the power cord must be connected to the neutral
terminal located in the center of the terminal block.
The power leads must be connected to the lower left
and the lower right terminals of the terminal block.
Locate the copper ground strap on the
lower back of the range.
Loosen the upper center screw on the
terminal block.
Slide the open slotted end of the ground
strap under the upper center screw on the
terminal block. Make sure the ground strap
is all the way against the upper center screw
and tighten it in place.
Place the ground plate (removed earlier)
over the bottom of the ground strap, press
them against the range frame and attach
them with the ground screw (removed
earlier).
Insert the new power cord through the
strain relief. Allow enough slack to easily
attach the wires to the terminal block.
Insert the 3 terminal screws (removed
earlier) through each power cord terminal
ring and into the lower terminals of the
terminal block. Be certain that the center
wire (white/neutral) is connected to the
center lower position of the terminal block.
Tighten screws securely (approximately 20
inch-lbs.) into the terminal block.
Secure the strain relief in place in the
bracket by tightening the strain relief screws.
47
Read these instructions completely and carefully.
Ground strap
Terminal block
(appearance
may vary)
Neutral
terminal
Power cord
Ground
plate
Replace the Power Cord (Optional) Continued
Perform this step only if the power cord shipped on the range does not match your wall receptacle.
Ground strap
Open slotted end
3-Wire Power Cord Installation Option
Consumer Support
Operating Instructions
Safety Instructions
Installation Instructions
Tr
oubleshooting T
ips