GE Profile JB900TKWW, Installation Instructions Manual

8

Installation Instructions

INSTALL THE RANGE

ANTI-TIP DEVICE INSTALLATION

An 

Anti-Tip bracket

is supplied with

instructions for installation in a variety of
locations. The instructions include all
necessary information to complete the
installation. Read the 

Safety Instructions

and the instructions that fit your situation
before beginning installation.

WARNING:

• 

Range must be secured by 

Anti-Tip bracket

supplied.

• 

If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB2X7909.

• 

See instructions to install (supplied with bracket).

• 

Unless properly installed, the range could
be tipped by stepping or sitting on the door.
Injury may result from spilled hot liquids 
or from the range itself.

9

Typical installation of anti-tip bracket attachment to wall

Bracket

Screw must

enter wood

or metal

Wall plate

REPLACE THE WIRE COVER

Replace the wire cover on the range back
by sliding its left edge under the retaining
tabs and replacing the five screws removed
earlier. Make sure that no wires are pinched
between the cover and the range back.

8

REMOVE STORAGE DRAWER
ON MODELS WITHOUT BAKING
OR WARMING DRAWERS

Pull the drawer out until it stops.

Lift the front of the drawer until the 
stops clear the guide.

Remove the drawer.

C

B

A

11

Stop

Wire 
cover

5 screws to
replace wire cover

Retaining
tabs

Back of
range

PREPARE TO LEVEL MODELS
WITH BAKING OR WARMING
DRAWERS

Measure the height of your countertop 
at the rear of the opening (X).

Adjust two rear leveling legs so that the
rear of the cooktop is at the same height
as the counter (Y).
Slide unit into place.

C

B

A

10

X

Y